Assembly - Remington RM2BV Manual Del Operador

WARNING:
To avoid serious personal injury and
damage to the unit, shut the unit off before removing or
installing blower tubes, nozzles, vacuum tubes or the
vacuum bag.
ASSEMBLING THE UNIT AS A BLOWER
Installing the Blower Tube
1. Align the bumps on the upper end of the blower tube with the
slots on the blower outlet (Fig. 1).
2. Insert the blower tube into the blower outlet (Fig. 1).
3. While holding the handle, twist the blower tube clockwise until it
locks into place (Fig. 1).
Installing the Nozzle
1. Align the slots on the nozzle with the bumps on the lower end of
the blower tube (Fig. 2).
2. Install the nozzle onto the blower tube (Fig. 2).
3. While holding the blower tube, twist the nozzle clockwise until it
locks into place (Fig. 2). The tabs on the blower tube should
align with the tabs on the nozzle (Fig. 3).

ASSEMBLY

Bumps
Slot
Tabs
7
Slots
Blower
Outlet
Blower Tube
Fig. 1
Bump
Blower Tube
Nozzle
Fig. 2
Fig. 3
Handle
Tabs