Weighing; Resetting The Scale; Cleaning - ADE BE 1723 Instrucciones De Operación

Weighing

Weighing
WARNING against injuries
− Do not step onto the scale with wet feet or when its surface is damp.
Risk of slipping!
− Position yourself on the scale. Remain standing still and do not hold on to
anything.
The scale switches on and the display flashes shortly afterwards: The weight
measurement is displayed in the selected unit of measure.
A few seconds after you step off the weighing surface, the scale will switch off
automatically.
‚ The weight is displayed for up to approx. 10 seconds after leaving the
scale. When you step on the weighing platform using slight force, the
display shows "0.0" and you can weigh yourself again.
‚ Weigh yourself with as little clothing on as possible.
‚ Try to weigh yourself always at the same time and under consistent
conditions in order to obtain comparable values.

Resetting the scale

Reset the scale to factory settings if unusual or obviously incorrect values are shown on
the display.
1. Remove the batteries from the battery compartment and wait a moment.
2. Re-insert the batteries.
Pay attention to the correct polarity of the batteries (+/-).
After switching the scale on, you can weigh yourself as usual.

Cleaning

NOTE on material damage
− Do not immerse the scale in water or other liquids.
− Do not under any circumstances use harsh, scraping, or abrasive
cleaning agents or the like to clean the scale. If you do, the surface
could be scratched.
− Wipe down the scale as needed using a lightly dampened, soft cloth.
− Disinfect the weighing surface from time to time using a suitable disinfecting
agent (available at specialist retailers and pharmacies).
18
Bathroom Scale BE 1723