Description Of Terminals And Connectors; Description Of The Wires For Connecting Device To Surveillance Cameras - Urmet 1083/39 Manual De Instrucciones

8. Confi guration button (PROGRAM);
9. Connector for hearing aid coil (ILA) Ref. 1168/48;
10. Trimmer for adjusting speaker volume (RV1);
11. Module connection wire connector (OUT);
12. Label with MAC ADDRESS of the device;
13. Jumper provided to connect the door state sensor;
14. Terminal board;
15. Connector for managing the device for surveillance cameras.
4.

DESCRIPTION OF TERMINALS AND CONNECTORS

Composite video signal reference (earth) (from CCTV camera or device output for
V5
surveillance cameras)
Composite video signal input (from CCTV camera or device output for surveillance
V3
cameras)
]
PA Hall button
]
LINE Bus line in
]
SE2 Garage relay contacts
SE -
Pedestrian electrical lock with capacitance discharge actuation negative
SE + Pedestrian electrical lock with capacitance discharge actuation positive
5. DESCRIPTION OF THE WIRES FOR CONNECTING DEVICE TO
SURVEILLANCE CAMERAS
A wire is provided with the product for connecting the door unit via the connector (15) to and the surveillance
camera control device ref. 1083/69, for managing multiple cameras.
The camera control device Ref. 1083/69 must be set to default confi guration (default setting).
R
Surveillance camera device reset: green wire
T- Surveillance camera control device reference (earth): black wire
T+ Surveillance camera device control: yellow wire
12
8 9 10 11 12
REAR VIEW
13 14
Green (R)
Black (T-)
Yellow (T+)
T+ T- R
15
DS1083-118A