Essential Parameter Configuration (Without Wifi Connection); Configurable Parameters; Parameter 1: Door Unit Type; Parameter 2: Door Unit Id - Urmet 1083/39 Manual De Instrucciones

6. ESSENTIAL PARAMETER CONFIGURATION (WITHOUT WiFi
CONNECTION)

6.1. CONFIGURABLE PARAMETERS

The essential parameters can be confi gured directly on the door unit without needing a WiFi connection.
The confi guration is performed directly on the device. The parameters listed below can be confi gured and
the value can be set by means of LEDs (1) and (4).

6.1.1. PARAMETER 1: door unit type

This parameter is used to set the audio door unit as primary or secondary. All the users in the system may be
called from the main door unit. A secondary door unit may only call the users of the riser to which it belongs.
Users who receive the call can identify the source of the call by the tone.

6.1.2. PARAMETER 2: door unit ID

If main door unit type is set under previous parameter, this parameter can be used to change the ID from 0
to 1 because various main calling stations with different ID can be present in the system.
If, on the other hand, a "secondary" door unit type is set under previous parameter (which by default is
named riser 0), this parameter can be used to change the ID from 0 to 1 because two secondary calling
stations with different ID can be present in the same riser.

6.1.3. PARAMETER 3: door opener

This is used to manage lock door opener mode; possible options are "Free" or "Privacy". In "Privacy" mode,
the electric lock may only be activated by pressing the door opening button on the calling station when an
audio conversation has been established or when after having received a call or auto-on function either a
video connection has been established.
In "Free" mode, instead, the indoor station door opener button will only open the door unit electrical lock
only if the door unit is confi gured as main or the user belongs to the same door unit riser. This riser is defi ned
by the secondary door unit ID setting. This function is typically used for secondary stations.
The above applies to the vehicle and pedestrian gate electrical lock.

6.1.4. PARAMETER 4: call button enabling

This parameter can be changed to enable call buttons (2) and (5) present on the front part of the door unit.
Specifi cally, the buttons can be enabled on the call button only (5), on both buttons or on no button.

6.1.5. PARAMETER 5: button enabling to call switchboard

If the door unit was confi gured as main unit (by means of parameter 1), then call buttons (2) and (5) can be
enabled to call the switchboard.
If the buttons are enabled to call the switchboard (parameter 5 enabled) if will not be possible to
confi gure the call button enabling function (parameter 4).
DS1083-118A
13