Garland FUM FIRST MW Manual De Instrucciones página 23

The area within a radius of 15 meters around the
machine must be considered a risk zone in which no
one should enter while the machine is running (Safety
zone).
When necessary, use ropes and warning signs to
mark the safety zone.
Keep children and curious people away from the
work area while operating this machine. Distractions
can cause a loss of control. Make sure that children,
people or animals do not eat into your work area.
When the work must be done simultaneously by
two or more people, always check the presence and
location of the others in order to maintain a distance
between each person sufficient to ensure safety.
2.4. ELECTRIC SECURITY
Use only Garland batteries for this machine.
Use only the Garland charger to charge the Garland
batteries. Using a different battery or charger may
cause the battery to explode and the risk of fire.
Be sure to connect the charger to a 220 V and 50 Hz
DC power source.
The electrical plug of the charger of this machine
must match the base of the socket.
Never modify the plug in any way. Unmodified plugs
and matching bases will reduce the risk of electric
shock.
When using the battery charger, avoid body contact
with grounded surfaces such as pipes, radiators,
electric stoves and refrigerators. There is an increased
risk of electric shock if your body is grounded.
Do not expose this machine, charger or battery to
rain or wet conditions. The water that enters them will
increase the risk of electric shock.
Do not abuse the cable. Do not use the cable to carry,
lift or unplug the charger. Keep the cord away from
heat, oil, sharp edges or moving parts. Damaged or
tangled cables increase the risk of electric shock.
Never use this charger with the damaged cord or plug.
Before connecting the charger, check the plug and
cable for damage. If you discover any damage send
your machine to a technical service for repair. If the
cable is damaged or broken, unplug it immediately.
Damaged or tangled cables increase the risk of
electric shock.
The replacement of the plug or power cord should
always be done by the manufacturer or its technical
support service. It is recommended to connect this
charger to a residual differential device whose tripping
current is less than or equal to 30mA.
Never use a damaged connection base that does
not meet the regulations or requirements for this
charger.
Disconnect the charger from the power when
not in use to prevent damage in case of network
overload.
Charge the battery only with the charger supplied
with the machine, in a dry place with a temperature
between 0º C and 40º C.
Do not attempt to tamper with or open the battery and
/ or charger.
Do not short-circuit the battery and be careful when
handling it so as not to accidentally short-circuit it with
conductive elements such as rings, bracelets, keys,
etc. When the battery is short-circuited it increases in
temperature and may explode or burn.
23/94
English