KENMORE ELITE ULTRACLEAN 665.1281 Serie Manual De Uso Y Cuidado página 16

Lavavajillas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Removable Top Rack (on some models)
The removable rack allows you to wash larger items such as pots, roasters, and cookie sheets in the bottom rack.
IMPORTANT: Remove dishes prior to removing the top rack from dishwasher.
To remove the rack
1. To gain access to the track stops, pull the upper rack forward about halfway out of the tub.
2. To open, flip the track stop toward the outside of the tub.
3. After opening both track stops, pull top rack out of the rails.
Track stop open
Track stop closed
4. Close track stops and slide the tracks back into the dishwasher.
To replace the rack
1. Gently pull tracks forward in dishwasher until they stop. Open track stops.
2. Place the back wheels on each side of the rack into the track slot and roll them back into the tracks, but do not push the rack
all the way into the tub.
3. Insert front rack wheels on each side of the rack into the track slots.
4. Slide the rack into the dishwasher. The stops will automatically close when rack enters dishwasher.
Removable Top Rack - for Smooth Motion Rack™ (on some models)
The removable top rack allows you to wash larger items such
as pots, roasters, and cookie sheets in the bottom rack.
IMPORTANT: Remove dishes prior to removing the top rack
from the dishwasher.
To remove the rack:
To gain access to the removable tabs on the tracks/rails, pull
the upper rack forward about halfway out of the tub.
On one side, press the tab on the track in and pull up the front
end of the rack out of the track. Then repeat this step on the
other side to completely remove the front end of the rack.
Then remove the back end of the rack, by pulling the back end
out with a slightly forward then upward motion.
To replace the rack:
Pull the tracks forward about halfway out of the tub.
Removal
Along the sides of the racks are round attachment tabs. Align
the rack's back end attachment tabs with the cutout in the
track. Push down into place.
Pull the tracks completely out, and align the rack's front end
attachment tabs with the cutout in the track. Push down into
place. You will hear a snap when the front end of the rack is
secured into place on each side.
16

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido