Dishwasher Control Section; Dishwasher Feedback Section; Canceling A Cycle - KENMORE ELITE ULTRACLEAN 665.1281 Serie Manual De Uso Y Cuidado

Delay Hours (on some models)
Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak
hours when possible.
To delay the start:
1. Select a wash cycle and options.
2. Press the 4 Hour or 4-8 Hr Delay button.
3. Close the door.
4. Press START.
NOTE: Anytime the door is opened for more than 5 seconds (such as, to add a dish), close the door and the START button must be
pressed again to resume the delay countdown.
Control Lock Option
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When Control Lock is lit, all buttons are
disabled. The dishwasher door can still be opened/closed while the controls are locked.
To turn on Control Lock:
Press and hold CONTROL LOCK for 3 seconds. The Control Lock light will turn on.
NOTE: The dishwasher cannot start if the control is locked.
To turn off Control Lock
Press and hold CONTROL LOCK for 3 seconds. The Control Lock light turns off.
Selecting Cycles and Options
1. To repeat the same cycle/options used on previous cycle, press START once to show which selections you used. To change
cycle, select desired cycle.
2. Select the desired options, then close the door and press START to start the cycle. Not all options are available for every cycle.
If an invalid option is selected for a given cycle, the lights will flash.
Turning OFF/ON the Sound
Press and hold HIGH TEMP for 3 seconds to toggle sound On and Off. The sound will not deactivate for cycle interruption or
service required messages.
1. Close the door.
2. Press the Cancel button.
3. The dishwasher starts a drain cycle if water remains in bottom of dishwasher. Let the dishwasher drain completely. The Cancel
light turns off after 2 minutes.
22

Dishwasher Control Section

Dishwasher Feedback Section

Canceling A Cycle