Steren RM-100 Manual De Instrucciones página 18

3. Hold down the "SET" key and
release it
indicator blinks for three times. The
operation indicator is on and it is
now the code entering state.
Indication light is on
5. The indicator will be off after the
code is entered. If the operation
indicator is on after blinking for
three times, the code entered is
wrong and should be reentered.
Indication light is off
18
after the operation
4. Enter the 5 - digit code you
searched out, as figure:
6. You can check whether the
function keys on the
controller are
operation (such as power, menu and
other keys). If they are under normal
operation, the setup is successful. If
they are not under normal operation,
please repeat steps 1-6.
remote
under normal