Nokia N73 Manual Del Usuario página 92

To edit the settings of an access point, select
Edit. Follow the instructions from your service provider.
Connection name—Enter a descriptive name for the
connection.
Data bearer—Select the data connection type.
Depending on the data connection you select, only certain
setting fields are available. Fill in all fields marked with
Must be defined or with a red asterisk. Other fields can
be left empty, unless you have been instructed otherwise
by your service provider.
To be able to use a data connection, the network service
provider must support this feature, and if necessary,
activate it for your SIM card.
Packet data
Follow the instructions from your service provider.
Access point name—You obtain the access point name
from your network operator or service provider.
User name—The user name may be needed to make a data
connection, and is usually provided by the service provider.
Prompt password—If you must enter the password every
time you log in to a server, or if you do not want to save
your password in the device, select Yes.
Password—A password may be needed to make a data
connection, and is usually provided by the service provider.
Authentication—Select Normal
Options >
or Secure.
Homepage—Depending on the access point you are setting
up, enter the Web address or the address of the multimedia
messaging center.
Select Options > Advanced settings
following settings:
Network type—Select the Internet protocol type to use:
IPv4 settings or IPv6 settings. The other settings depend
on the selected network type.
Phone IP address (for IPv4 only)—Enter the IP address
of your device.
DNS address—In Primary name
of the primary DNS server. In
the IP address of the secondary DNS server. Contact your
Internet service provider to obtain these addresses.
Proxy serv. address—Define the address for the proxy server.
Proxy port number—Enter the proxy port number.
Packet data
The packet data settings affect all access points using
a packet data connection.
Packet data conn.—If you select
you are in a network that supports packet data, the device
registers to the packet data network. Starting an active
packet data connection (for example, to send and receive
e-mail) is quicker. If there is no packet data coverage, the
device periodically tries to establish a packet data connection.
to change the
serv.:, enter the IP address
Second. name server:, enter
When available and
91