Speaker Impedance Settings - Pioneer A-40AE Manual De Instrucciones

Speaker impedance settings

1
2
3
8Ω
Depending on the speakers you connect and how you
connect them, you may need to change the speaker
impedance setting on this unit. Refer to the page describing
speaker connection (p8, 9, 10) and do the following
procedures if the change is required.
1. Press and hold DIRECT until some indicators, such as
3"
the input source indicators "CD/SACD" and "LINE 1", start
blinking on the unit.
0 The unit has switched to the setting mode when the
indicators blink and the current setting is displayed.
2. Take your finger off DIRECT for a moment.
3. Press and hold DIRECT again to change the setting. The
following content switches alternately by pressing and
holding the button.
- 4 ≠: "CD/SACD" and "LINE 1" indicators are blinking
- 8 ≠ (default value): "CD/SACD", "LINE 1", "LINE 2",
and "LINE 3" indicators are blinking
0 The setting mode ends after 5 seconds elapse with no
operations performed.
3"
4Ω
Preparations
15
En