Makita HR5001C Manual De Instrucciones página 6

Ocultar thumbs Ver también para HR5001C:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
2
Side grip
1
CAUTION:
Always use the side grip to ensure operating safety
when drilling in concrete, masonry, etc.
The side grip swings around to either side, allowing easy
handling of the tool in any position. Loosen the side grip
by turning it counterclockwise, swing it to the desired
position and then tighten it by turning clockwise.
Bit grease (optional accessory)
Coat the bit shank head beforehand with a small amount
of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck
lubrication assures smooth action and longer service life.
Installing or removing the bit
Clean the bit shank and apply bit grease before installing
the bit.
2
1
Insert the bit into the tool. Turn the bit and push it in until
it engages.
003581
1. Side handle
2. Clamp nut
003147
1. Side grip
003150
1. Bit shank
2. Bit grease
1
2
If the bit cannot be pushed in, remove the bit. Pull the
chuck cover down a couple of times. Then insert the bit
again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
Bit angle
(when chipping, scaling or demolishing)
2
The bit can be secured at 12 different angles. To change
the bit angle, depress the lock button and rotate the
change lever so that the pointer points to the "O" symbol.
Turn the bit to the desired angle.
Depress the lock button and rotate the change lever so
that the pointer points to the
that the bit is securely held in place by turning it slightly.
2
6
003161
1. Bit
2. Chuck cover
003168
1. Bit
2. Chuck cover
1
2
003172
1. Lock button
1
2. Change lever
3. Pointer
4. O symbol
3
4
symbol. Then make sure
003176
1. Change lever
1
2. Pointer

Publicidad

Tabla de contenido
loading

Tabla de contenido