Makita XBU02 Manual De Instrucciones página 35

Electronic function
Constant speed control
tion speed regardless of load conditions.
Soft start feature
ASSEMBLY
WARNING:
Always be sure that the tool is
switched off and battery cartridge is removed
before carrying out any work on the tool.
switch off and remove the battery cartridge may result
WARNING:
Never start the tool unless it is
completely assembled. Operation of the tool in a
partially assembled state may result in serious per-
Installing the handle
1. Attach the upper and lower clamps on the damper.
2.
1
2
1. 2. Handle 3. Upper clamp
4. Damper 5. Lower clamp 6.
CAUTION:
Do not remove or shrink the
spacer. Doing so lose the balance of the tool and
-
3 6
4
5
11 ENGLISH
Hex wrench storage
CAUTION:
Be careful not to leave the hex
wrench inserted in the tool head. It may cause
keep it from being lost.
1
1.
stored on the handle as illustrated.
1.
Correct combination of the cutting
tool and the protector
CAUTION:
Always use the correct combi-
nation of cutting tool and the protector. A wrong
combination may not protect you from the cutting tool,
Cutting tool
Nylon cutting head
1
-
Protector