Makita XBU02 Manual De Instrucciones página 38

When using a nylon cutting head (bump & feed
type)
provided with a bump & feed mechanism.
the ground while rotating.
1. Most effective cutting area
NOTICE:
The bump feed will not operate prop-
erly if the nylon cutting head is not rotating.
NOTE: If the nylon cord does not feed out while
tapping the head, rewind/replace the nylon cord
by following the procedures in the section for the
maintenance.
MAINTENANCE
WARNING:
Always be sure that the tool is
switched off and battery cartridge is removed
before attempting to perform inspection or main-
tenance on the tool.
the battery cartridge may result in serious personal
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Centers, always using Makita replacement parts.
Replacing the nylon cord
WARNING:
Use only the nylon cord with
Never use heavier line, metal wire, rope or the
like.
WARNING:
Always remove the nylon cutting
head from the tool when replacing the nylon cord.
WARNING:
Make sure that the cover of the
nylon cutting head is secured to the housing
properly as described below.
secure the cover may cause the nylon cutting head to
method of replacing the nylon cord varies depending on
the type of the nylon cutting head.
1
14 ENGLISH