Battery
Wing Notch
Grill Body Slot
Cooking Grills
Heat Distribution
Plates
Supports
Igniter Cap
Step 15
Attach the lid handles by removing the
pre-attached bolts on the handle. Insert
the screws through the grill lid holes
and into the handle. Secure tightly.
Repeat for other lid handle.
Step 16
Lift wind guard and unfold wings. Insert
notch on wings into slots of grill body.
Step 17
Place the heat distribution plates on
lower level of grill body assembly
directly above burners.
Step 18
Place cooking grills on support ribs
directly above heat distribution plates.
Step 19
Igniter battery holder is located on
the control panel. Remove igniter cap
and insert battery with positive end
of battery toward igniter cap. Ensure
spring is in place inside igniter cap.
Replace igniter cap and make sure the
igniter is working properly.
26