Pairing; What Is Pairing; Procedures Of Pairing - Sony DR-BT100CX Manual De Instrucciones

Pairing

What is pairing?

Bluetooth devices need to be "paired"
with each other beforehand.
Once Bluetooth devices are paired,
there is no need for pairing again,
except in the following cases:
 Pairing information is deleted after
repair, etc.
 This unit is paired with 9 or more
devices. This unit can be paired with
up to 8 devices; if a new device is
paired after 8 devices have been
paired, the device whose latest
connection time is the oldest among
the 8 paired devices is replaced by
the new one.
 When recognition of the unit by the
device to be connected is deleted.
 This unit is initialized (page 25). All
pairing information is deleted.
10
US
DR-BT100CX_4-130-037-51(1)

Procedures of pairing

1 Place the Bluetooth device
within 1 m (3 ft) of this unit.
2
Press and hold the PAIRING
button for 2 seconds or more to
standby for pairing while the
unit is turned off.
The indicator (blue) and indicator
(red) flash in turn and the unit
enters into pairing mode.
Note
If pairing is not established within about
5 minutes, pairing mode will be canceled
and this unit will turn off. In this case,
start over from step 1.
3
Perform
the Blu
this un
The list
on the d
device. T
"DR-BT
is not di
Notes
 For det
instruc
Bluetoo
 When
that ca
devices
may pa
this un
pairing
is set b
device,
this un
4
Select "
display
5
If Passc
on the
device,
Pairing
indicato
message
complet
of some
* Passcode
code," "P
Note
Passcode
dependin
device. F
instructio
device.