Calling While Playing Back Music - Sony DR-BT100CX Manual De Instrucciones

Calling while playing back music

The Bluetooth connection using HFP or HSP as well as A2DP is necessary to
make a call while playing back music.
For example, to make a call using a Bluetooth mobile phone while listening to
music on a Bluetooth compatible music player, this unit needs to be connected to
the mobile phone using HFP or HSP.
Make a Bluetooth connection between this unit and the device in
use following the procedures outlined below.
1 Make a Bluetooth connection between this unit and the mobile phone
in use with HFP or HSP following the procedures outlined in "Calling"
(page 17).
2 Operate the Bluetooth device (music player or mobile phone) used for
playing the music to make a Bluetooth connection to this unit using
A2DP.
To make a call while playing
back music
1
Press the multi function button
while playing back music (page
19), or operate your Bluetooth
mobile phone to make a
telephone call.
If no dial tone is heard on this unit,
press and hold the multi function
button for about 2 seconds.
20
US
DR-BT100CX_4-130-037-51(1)
To receive a call while playing
back music
When an incoming call arrives, the
music pauses and the ring tone is
heard from this unit.
1
Press the multi function button
and talk.
After finishing the call, press the
multi function button. This unit is
switched back to music playback.
When no ring tone is heard
even if an incoming call arrives
1
Stop music playback.
2
When ringing, press the multi
function button and talk.
ADDITIONA
Precau
On Bluetoot
 Bluetooth w
within a ran
30 feet).
Maximum
vary depen
metal, wall
environme
 The antenn
illustrated i
sensitivity o
will improv
the built-in
Bluetooth d
The comm
when the o
antenna of
unit.
 The followi
sensitivity o
– There is
body, m
and Blue
– A device
as a wire
telephon
near this
 Because Blu
LAN (IEEE
frequency,
occur and r
speed deter
connection
wireless LA
perform th