Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
Timer Function
• Press the TIMER ICON to set the countdown for the unit's main power.
•
If the unit is powered OFF, you can press the TIMER ICON to power ON the unit. The
emberbed will glow at the lowest brightness setting unless a different setting was saved in
the memory.
• Press the TIMER ICON again to scroll through the timer settings, which are: 30, 1h, 2h, 3h,
4h, 5h, 6h, 7h, 8h,
• When the timer reaches zero, it will turn OFF the main power and will maintain all the settings
in memory.
Downlight Function
• Press the DOWNLIGHT ICON to power the LED downlights ON or OFF
• If the unit is powered OFF, you can press the DOWNLIGHT ICON to power ON the unit. The
emberbed will glow at the lowest brightness setting unless a different setting was saved in
the memory.
HEATER OVERRIDE
The power to the heater can be disengaged to prevent the heater from being accidentally or
unintentionally powered on. This feature is primarily added to help prevent children from powering
on the heater when it is not desired.
• To engage the heater override function press and hold the HEATER ICON for 10 seconds. The
symbol E3 will display and then go blank while beeping 3 times. The heater function is now
locked. If the HEATER ICON is pressed again E3 will appear then fade.The Flame, Downlight
and Timer functions will operate normally. Only the heater and blower are disengaged.
• To unlock the heater function, press and hold the HEATER ICON for 10 seconds. The symbol
E3 will display and then go blank while beeping 3 times. The heater function is now engaged.
By pressing the HEATER ICON again you will be able to adjust the heat temperature to your
desired temperature.
MEMORY FUNCTION
This unit has a memory function that allows you to turn off the MAIN POWER and retains all the other
function settings (excluding the TIMER function).
• When the unit's main power is OFF, press the POWER ICON once on the insert control panel or
on the remote control to power the unit ON and "wake up" the individual function at the last setting.
Press the icon again to adjust it and press the main POWER ICON on the insert or on the remote
control to turn the unit OFF and save the new setting into memory.
• When the unit is powered ON, the LED readout will show the saved temperature setting. If a
temperature setting was not saved, it will show the flame brightness setting saved in memory. If
neither one has a setting saved to memory, then only the emberbed will glow (as a power light
indicator).
•
To reset the memory, hold down the main POWER ICON for 10 seconds at any time. When this
happens, the LED readout will blink with three zeros three times the unit will be shut down.
•
Another way to reset the memory is to unplug the unit from the wall.
(CONT'D)
9h,OFF.（30 means 30 minutes)
13
Publicidad
