Installing The Light - Federal Signal 24XST Instrucciones De Instalación Y Mantenimiento

Installation and Maintenance Instructions

Installing the Light

EXPLOSION HAZARD—This light fixture is not backward
compatible with older products. Do not use this light fixture
with the Series A versions of model CMXC, CMXC-R, PMXC,
PMXC-R, WMXC, or WMXC-R mounting accessories. Failure to
follow this warning may result in personal injury or death.
REVERSE POLARITY/MISWIRING—The DC lights are polar-
ity sensitive and MAY BE DAMAGED by incorrect electrical
hookup. When connecting the DC strobe light to the voltage
supply lines, POLARITY MUST BE OBSERVED. In addition,
damage will if the voltage rating of the model is exceeded.
The Model 24XST should be installed per the NEC or CEC,
STATE and LOCAL CODES. Alternate installation locations and/
or orientations should only be performed with the approval of the
authority having jurisdiction.
NOTE: The recommended mounting position of this light is in a
vertical orientation with the dome facing down.
The instructions below are for lights using the ceiling mount option
(CMXC-SB). Refer to instruction manual 25500050 for the pendent
mount (PMXC-SB) and wall-mount option (WMXC-SB).
The glass dome is part of the explosion-proof housing. In applica-
tions where the dome requires added protection, a separately pur-
chased metal guard (Part No. DGXC-SB) can be readily attached.
Wiring must comply with Article 500 of the National Electrical
Code or Canadian Electrical Code and the local authority having
jurisdiction. For marine applications all wiring, including the
supply wire, must be stranded wire and meet the USCG (CFR46)
Section (110-113).
Model 24XST
7