Technical Information; Installation Considerations - Hansgrohe Showerpipe 26068 1 Serie Instrucciones De Montaje / Manejo / Garantía

Tabla de contenido

Publicidad

English

Technical Information

Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Flow rate (max.)
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.

Installation Considerations

Inspect
the
damage
before
for shipping damage made after the
showerpipe is installed will not be honored.
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• This showerpipe requires showerpipe rough
16181181(not included).
• Protection against backflow is provided by check
valves.
• Do not install this showerpipe in a steam shower.
• Make sure that the wall is strong enough to support
the showerpipe. The wall must be reinforced at the
mounting points. The area where the top mounting
piece is to be installed must be flat and free of
protruding grout joints, etc.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
5.3 GPM (20 L/min)
showerpipe
for
installation.
• The enclosed screws and anchors are suitable for
shipping
Claims
a solid surface wall. For other wall constructions,
select mounting hardware and reinforcement
suitable for that specific construction.
• This showerpipe is for use with shower heads rated
at 1.1 GPM (4.2 l/min) or higher.
• To prevent scald injury, the maximum output
temperature of the shower valve must be no
higher than 120°F (49°C). In Massachusetts, the
maximum output temperature can be no higher than
112°F (44°C).
This showerpipe must not be used as a grab
bar. If a grab bar is required, install one
separately.
The shower arm is intended to hold the
showerhead only. Do not use it to hold
other objects.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.

Publicidad

Tabla de contenido
loading

Tabla de contenido