Rear Panel - Pioneer X-HM76 Manual De Instrucciones

> Before Start > Part Names

Rear Panel

1. Power cord
2. Wireless antenna: Used for Wi-Fi connection or when using a BLUETOOTH enabled
device. Adjust their angles according to the connection status.
3. Speaker terminals: Connect speakers with speaker cables.
0 You can connect banana plugs by removing the cap on the tip of the jack. When using
banana plugs, first tighten the speaker terminals and then insert the banana plugs.
4. FM ANTENNA jack: Connect the supplied indoor FM antenna.
5. LINE IN jack: You can play the audio from an external device such as a television
connected with an analogue audio cable.
6. SUBWOOFER PRE OUT jacks: Connect a subwoofer with built-in amplifier.
7. USB port: Connect a USB storage device or HDD (hard disk drive) to play music files. You
can also supply power (maximum 5 V/1 A) to USB devices with a USB cable.
> Install > Initial Setup
 
> Playback

   
8. NETWORK jack: Connect to the network with a Ethernet cable.
9. DIGITAL IN OPTICAL jack: You can play the digital audio from an external device such as
a television connected with a digital optical cable.
10.AM ANTENNA jack: Connect the supplied AM loop antenna.
Supplementary information | Advanced Setup | Others
 
90°
180°

E
N

5