Husqvarna SRD17530 Manual De Operario página 9

TO INSTALL BAGGER SPRING LATCH
(See Fig. 12 and 13)
The bagger spring latches are located on the back plate (1),
one in each of the bottom corners.
• Before installing, tractor engine must be shut off and
parking brake engaged.
• Install each bagger spring latch with the loop end (2)
down and facing towards the bagger assembly.
• Place the mounting bolt (3) through the curved end of
the bagger spring latch, through the back plate, and
secure with nut (4) as shown. Tighten firmly.
3
• The bottom of the bagger assembly should contact the
loop end so that it is held securely when closed.
NOTE: If the bagger assembly height is adjusted, it may
be necessary to adjust the bagger spring latch. To adjust,
remove the nut (4) and move the bagger spring latch to the
appropriate hole in the backplate (1), ensuring the bagger
assembly will be securely closed. Retighten nut securely.
TO ADJUST BAGGER FULL LEVER/PADDLE
(See Fig 11)
• Before adjusting, tractor engine must be shut off and
parking brake engaged.
3
ASSEMBLY
1
2
Fig. 17
Fig. 13
2
1
4
3
Fig. 11
• For the heaviest/wet grasses, remove paddle (3).
• For lighter grasses use the paddle (3) on setting "1",
"2", or "3" ("3" being for the lightest or dry grass).
• Choose your setting and rotate the bagger paddle (3)
so that the desired number (setting) faces you.
• Setting may be changed by loosening fasteners (4 and
5), removing/rotating paddle (3), and tightening again.
4
5
9