Husqvarna SRD17530 Manual De Operario página 24

Ocultar thumbs Ver también para SRD17530:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SERVICE AND ADJUSTMENTS
TO REPLACE MOWER BLADE DRIVE BELT
(See Fig. 41)
The mower blade drive belt may be replaced without tools.
Park the tractor on level surface. Engage parking brake.
BELT REMOVAL -
Remove mower from tractor (See "TO REMOVE
MOW ER" in this section of manual).
Work belt off mandrel pulley and idler pulleys.
Pull belt away from mower.
BELT INSTALLATION -
Work belt around mandrel pulley and idler pulleys.
Make sure belt is in all pulley grooves and in side all
belt guides.
Install mower (See "TO INSTALL MOWER" in this
section of manual).
MANDREL
PULLEY
TO CHECK BRAKE
If tractor requires more than five (5) feet to stop at highest
speed in high est gear on a level, dry concrete or paved
surface, then brake must be serviced.
You may also check brake by:
Park tractor on a level, dry concrete or paved surface,
depress brake pedal all the way down and engage
parking brake.
Place gear shift lever in neutral (N) position.
The rear wheels must lock and skid when you try to manu-
ally push the tractor forward. If the rear wheels rotate,
then the brake needs to be serviced. Contact a qualified
service center.
TO REPLACE MOTION BELT DRIVE
(See Fig. 42)
Park the tractor on level surface. En gage parking brake.
For as sis tance, there is a belt installation guide decal on
bottom side of left footrest.
PUL LEYS
Fig. 41
BELT REMOVAL
Remove mower (See "TO RE MOVE MOWER" in this
section of manual).
NOTE: Observe entire motion drive belt and position of all
belt guides and keepers.
Remove belt from stationary idler (A) and clutching
idler (B).
Pull belt slack toward rear of trac tor. Carefully remove
belt up wards from trans mis sion input pulley and over
cooling fan blades (D).
Remove belt downward from engine pulley (E).
Slide belt toward rear of tractor, off the steering plate
(F) and remove from tractor.
BELT INSTALLATION
Install new belt from tractor rear to front, over the steer-
ing plate (F) and above clutch brake pedal shaft (G).
Pull belt toward front of tractor and roll belt onto engine
pulley (E).
Pull belt toward rear of tractor. Carefully work belt down
around transmission cooling fan and onto the input
pulley (D). Be sure belt is inside the belt keeper.
Install belt through stationary idler (A) and clutch ing
idler (B).
IDLER
Ensure belt is in all pulley grooves and in side all belt
guides and keep ers.
Install mower (See "TO IN STALL MOWER" in this
sec tion of manual).
D
24
A
B
Fig. 42
E
F
G

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido