Problems And Solutions; Technical Features - Chicco SterilNatural 2in1 Manual De Instrucciones

2. Empty out any remaining water (fig. 6) taking care, in the FULL
SIZE and COMPACT configurations, not to wet the plug and/or
power cable (f ).
3. Dry the heating plate/container (e), motor body (c), rack unit
(b) and the lid (a) with a soft cloth.
REMOVING LIMESCALE
When the steriliser is used, it is normal for deposits of limescale
to form on the heating plate/container (e). These can vary in size
and intensity according to the hardness of the water used in the
appliance. An excessive deposit of limescale could reduce the
performance of the appliance and damage it over the long term.
It is therefore recommended that the appliance be descaled at
least once a week or each time that deposits of limescale are
found on the heating plate/container (e).
1. Pour 200 ml of a solution composed of equal parts of white

PROBLEMS AND SOLUTIONS

Problem
The steriliser does not finish the cycle /
is noisy.
The steriliser does not switch on.
The feeding bottles are stained at the end
of the sterilisation cycle.
The sterilisation cycle lasts for longer than
the time indicated on the packaging or in
the instruction manual.
N.B. IMPORTANT: If none of the solutions indicated above solves the problem, please contact Artsana Customer Service.

TECHNICAL FEATURES

Codes 00007392000000
Model: 06781
Power: 220-240V ~ 50/60Hz
Power: 450 W
Made in China
wine vinegar and water into the heating plate/container (e).
2. Leave it to work until the limescale has dissolved (approxi-
mately one night). Never switch the steriliser on when the con-
tainer is being soaked in the water-white vinegar solution.
3. Empty out the heating plate/container (e).
4. Remove any residue with a soft cloth and rinse several times,
pouring 200 ml of drinkable tap water into the heating plate/
container (e) and empty out. Finally, dry the appliance carefully
with a soft dry cloth before using it again.
Possible Cause
Excessive limescale deposit on the heating
plate/container (e).
There is no power.
The plug is not connected properly.
The main ON/OFF switch (h) is in the 0
(OFF) position.
Excessive limescale deposit on the heating
plate/container (e).
Excessive limescale deposit on the heating
plate/container (e).
Too much water inside the heating plate/
container (e).
13
WARNING: do not place the appliance under running
water in its FULL SIZE and COMPACT configurations.
Solution
Clean the heating plate/container (e)
by removing the limescale with white
wine vinegar (see the section "Removing
limescale").
Check that there is power in the mains.
Verify that the plug has been connected
properly and that it is in good condition.
Move the main ON/OFF switch (h) to I
(ON).
Clean the heating plate/container (e)
by removing the limescale with white
wine vinegar (see the section "Removing
limescale").
Clean the heating plate/container (e) by
removing the limescale with vinegar (see
the section "Removing limescale").
Place the correct quantity of water inside
the heating plate/container (e) and restart
the sterilisation cycle (please see the
section "how to prepare and use the ap-
pliance").