•
Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
•
Before you clean with water, clean with a brush.
Remove grass cuttings and dirt on and around the
transmission, the transmission air intake, and the
engine.
•
Use running water from a hose to clean the product.
Do not use high pressure.
•
Do not point the water at electrical components or
bearings. Detergent usually increases the damage.
•
To clean the cutting deck, put it in the servicing
position and clean it with a water hose.
•
When the product is clean, start the cutting deck for
a short period to blow off remaining water.
To clean the engine and the muffler
Keep the engine and muffler free from grass cuttings
and dirt. Grass cuttings soaked in fuel or oil on the
engine can increase the fire risk and the risk that the
engine becomes too hot. Let the engine cool before it is
cleaned. Clean with water and a brush.
Grass cuttings around the muffler dry quickly and are a
fire risk. Use a brush or remove the grass cuttings with
water when the muffler is cold.
To clean the cold air intake of the
engine
WARNING:
air intake rotates and can cause injury to
your fingers.
•
Make sure that the intake grille on the engine cover
is not blocked. Remove grass and dirt with a brush.
18
Stop the engine. The cold
•
Open the engine cover. Make sure that the engine
cold air intake is not blocked. Remove grass and dirt
with a brush.
•
Examine the air duct, found on the inner surface of
the engine cover. Make sure that the air duct is clean
and does not rub against the cold air intake.
To remove the covers
To open the engine cover
1. Fold the seat forward.
2. Release the clip on the engine cover with the tool
attached to the ignition key.
3. Fold the engine cover rearward.
To remove and install the air filter cover
1. Turn the 2 knobs ¼ turn counterclockwise.
2. Remove the air filter cover.
3. Install in the opposite sequence.
1686 - 001 - 03.11.2021