Black and Decker HP128F3 Manual De Instrucciones página 6

ENGLISH
Charge only at ambient temperatures between 10 °C and

40 °C.
Charge only using the charger provided with the tool.

When disposing of batteries, follow the instructions given

in the section "Protecting the environment".
Chargers
Use your Black & Decker charger only to charge the

battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.

Have defective cords replaced immediately.

Do not expose the charger to water.

Do not open the charger.

$ Do not probe the charger.

+ The charger is intended for indoor use only.
-
Read the instruction manual before use.
The charger automatically shuts off if the ambient
temperature becomes too high. As soon as the
ambient temperature has cooled down, the charger
j
will resume operating.
Charge only at ambient temperatures between 10 °C
U
and 40 °C.
y Charging process completed
Charging
# Electrical safety
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit with
a regular mains plug.
If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Forward/reverse slider
3. Chuck
6
4. Mode selector / torque adjustment collar
5. Two-gear selector
6. Bit holder
7. Battery
8. Side handle (HP188F3)
Fig. A
9. Charger
10. Charger receptacle
11. Charging indicator
12. End of charge indicator
Assembly
Warning! Before assembly, remove the battery from the tool.
Fitting and removing the battery (fig. B)
To fit the battery (7), line it up with the receptacle on the

tool. Slide the battery into the receptacle and push until
the battery snaps into place.
To remove the battery, push the release button (13) while

at the same time pulling the battery out of the receptacle.
Fitting the battery cap (fig. C)
Warning! Fit the cap (14) to the battery (7) for transportation
and storage.
Fitting the side handle
Loosen the side handle (8) by turning it counterclockwise.

Slide the side handle over the chuck and onto the housing.

Tighten the side handle by turning it clockwise.

Fitting and removing a drill bit or screwdriver bit
(fig. D)
This tool is fitted with a keyless chuck to allow for an easy
exchange of bits.
Lock the tool by setting the forward/reverse slider (2) to

the centre position.
Open the chuck by turning the sleeve (15) with one hand

while holding the tool with the other.
Insert the bit shaft (16) into the chuck.

Firmly tighten the chuck by turning sleeve (15) with one

hand while holding the tool with the other.
This tool is supplied with a double-ended screwdriver bit in the
bit holder (6).
To remove the screwdriver bit from the bit holder, lift the bit

from the recess.
To store the screwdriver bit, firmly push it into the holder.

Use
Warning! Let the tool work at its own pace. Do not overload.