Operation; Start And Stop; Operating - Chicago Pneumatic CP 0012 Instrucciones Originales

Safety and operating instructions
♦ To prevent an accidental start: switch off the air
supply and bleed the machine by pressing the
start and stop device. Disconnect the machine
from the power source.
♦ Before inserting a tool, lubricate the tool shank
with grease.
♦ Close the tool retainer and check the lock function
by tugging the inserted tool sharply.
CP 0012, Rd. 0.680 and H 0.580
A
1. Slide the retainer over the chisel.
2. Rotate and lock the chisel into the retainer.
3. Fit the retainer together with the chisel on the
cylinder.
4. Lock the retainer by inserting the lock coil (A).
CP 0012, H19x50
1. Slide the retainer over the shank and collar onto
the chisel.
2. Open the buffer (B) and place it on the chisel
between the retainer and the collar.
3. Insert the chisel shank into the cylinder, and
screw the retainer onto the cylinder with hand
force until it is tight.
14
B

Operation

WARNING Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
► Learn how the machine is switched off in the event
of an emergency.
Stop the machine immediately in all cases of
►
power supply interruption.

Start and stop

A
B
♦ Start the machine by squeezing the trigger ( to
position A ), while firmly holding the handle.
Stop the machine by releasing the trigger. The
♦
trigger will then return to the stop position (B).

Operating

Starting a cut
Stand in a stable position with your feet well away
♦
from the inserted tool.
Press the machine against the working surface
♦
before you start.
Start collaring at such a distance from the edge
♦
that the machine is capable of breaking the
material without levering.
♦ Never try to break off too large pieces. Adjust the
breaking distance (A) so that the inserted tool
does not get stuck.
9800 0548 90b | Original instructions
CP 0012
A