Safety Notes; Important Notes; Functions; Notes On Digital Operation - Trix Minitrix Metronom Manual De Instrucciones

Safety Notes

• Analog 14 volts DC, digital 19 volts AC.
• Do not expose the model to direct sunlight, extreme changes
in temperature, or high humidity.
• The wire used for feeder connections to the track may be a
maximum of 2 meters / 78 inches long.
• WARNING! Sharp edges and points required for operation.

Important Notes

• The operating instructions and the packaging are a compo-
nent part of the product and must therefore be kept as well as
transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or spare
parts.
• The warranty card included with this product specifies the
warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html
• The LEDs in this item correspond to Laser Class 1 according
to Standard EN 60825-1.
6

Functions

• Built-in electronic circuit for optional operation with
a conventional DC train controller (max. ±14 volts),
Trix Systems, Trix Selectrix (SX1), or digital systems adhering
to the NMRA standards.
• Automatic system recognition between digital and analog
operation.
• No automatic system recognition between the digital sys-
tems.
• Triple headlights in the front, dual red marker lights in the
rear, that change over with the direction of travel.
• Interior lighting can be installed in this car.
Installation only by the Märklin Repair Service.
Headlights
Interior lights

Notes on digital operation

• When operating in a digital system for the first time (SX1, SX2,
or DCC), the decoder must be set to this digital system. To do
this, the decoder must be programmed once in this digital
system (example: change the address).
• Address set at the factory:
DCC: 3
SX1: 1
SX DCC
F0
F1