Basic Installation - Alcad GRF-204 Manual Del Usuario

V I D E O P O R T E R O E L E C T R Ó N I C O - V I D E O D O O R E N T R Y S Y S T E M S - V I D É O P O R T I E R É L E C T R O N I Q U E
INSTALACIÓN BÁSICA

BASIC INSTALLATION

INSTALLATION STANDARD
ESQUEMA UNIFILAR - SINGLE-WIRED DIAGRAM - SCHÉMA À UN FIL
KIT 1 VIVIENDA
1 DWELLING KIT
KIT 1 LOGEMENT
Funcionamiento - Operation - Fonctionnement
Nota:
MAKING A CALL. SYSTEM ACTIVATED.
The monitor associated to the pushbutton receives the call, emitting an alert signal and turning on the screen. You are allowed a certain
period of time to answer. Once this period has expired, the system reverts to being on standby. When the receiver of the monitor is
picked up, communication will be established with the entrance panel, thereby starting the time allowed for communication. During
this period of time, you can open the door from the monitor. You can also extend the conversation time (see page 4). In this case, and
if the receiver of the other dwelling is picked up, communication cannot take place with the entrance panel and, automatic switch-on
will not be possible.
When the time allowed for conversation expires, or when the user hangs up the receiver, the system reverts to being on standby.
Note: you will find the time-settings of the system on page 3.
Remarque:
KIT 2 VIVIENDAS
2 DWELLINGS KIT
KIT 2 LOGEMENTS
SECTION TABLE
Up to 25 m -
Up to 100 m -
Use separate cable hose.
Section according to the number of monitors/telephones in the dwelling.
W