Blade Guard - Makita LS003G Manual De Instrucciones

Blade guard

WARNING:
Never defeat or remove the blade
guard or the spring which attaches to the guard.
An exposed blade as a result of defeated guarding
may result in serious personal injury during operation.
WARNING:
Never use the tool if the blade
guard or spring are damaged, faulty or removed.
Operation of the tool with a damaged, faulty or
removed guard may result in serious personal injury.
CAUTION:
Always maintain the blade guard
in good condition for safe operation. Stop the
operation immediately if there are any irregularity
of the blade guard. Check to assure spring loaded
return action of guard.
When lowering the handle, the blade guard raises
automatically. The guard is spring loaded so it returns to
its original position when the cut is completed and the
handle is raised.
► 1. Blade guard
Cleaning
If the transparent blade guard becomes dirty, or saw-
dust adheres to it in such a way that the blade and/or
workpiece is no longer easily visible, remove the battery
cartridge and clean the guard carefully with a damp
cloth. Do not use solvents or any petroleum-based
cleaners on the plastic guard because this may cause
damage to the guard.
Follow the step-by-step instructions listed on how to
prepare for cleaning.
1. Make sure that the tool is switched off and the
battery cartridge is removed.
2. Turn the hex bolt counterclockwise using the
supplied hex wrench while holding the center cover.
3.
Raise the blade guard and center cover.
4.
When cleaning is complete, return the center
cover and tighten the hex bolt by performing the steps
above in reverse.
5.
cover to their original positions and tighten the hex bolt.
► 1. Hex wrench 2. Hex bolt 3. Center cover 4. Blade guard
WARNING:
guard. If guard becomes damaged in course of time or
UV light exposure, contact a Makita service center for
replacement. DO NOT DEFEAT OR REMOVE GUARD.
1
Positioning kerf board
This tool is provided with the kerf boards in the turn base to
minimize tearing on the exit side of a cut. The kerf boards are
factory adjusted so that the circular saw blade does not contact
the kerf boards. Before use, adjust the kerf boards as follows:
1.
all the screws (3 each on left and right) securing the kerf boards.
► 1. Kerf board 2. Screw
NOTE: The far rear screws can easily be loosened and
tightened by turning the turn base at an angle. Make
sure to raise the handle fully when turning the turn base.
13 ENGLISH
Make sure to return the circular saw blade and center
2
1
Do not remove spring holding blade
Make sure to remove the battery cartridge. Then, loosen
2
3
4
1