Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Carefully square the side of the circular saw blade with
the top surface of the turn base using the triangular
rule, try-square, etc. by turning the 0° adjusting bolt
clockwise. Then tighten the knob firmly to secure the 0°
angle you have set.
1
3
► 1. Triangular rule 2. Saw blade 3. Top surface of
turn base
Check if the side of the circular saw blade squares with
the turn base surface once again. Loosen the screw on
the pointer. Align the pointer with 0° position in the bevel
angle scale and then tighten the screw.
45° bevel angle
NOTICE:
Before adjusting the 45° bevel angle,
finish 0° bevel angle adjustment.
Loosen the knob and fully tilt the carriage to the side
that you want to check. Check if the pointer indicates
the 45° position in the bevel angle scale.
1
► 1. Knob
If the pointer does not indicate the 45° position, align it
with the 45° position by turning the adjusting bolt in the
bevel angle scale on the opposite side of the base.
2
► 1. Left 45° adjusting bolt 2. Right 45° adjusting bolt
Adjust the sub fences on the sub bases if they are not
aligned with guide fences.
1.
the hex wrench.
2.
member, flat against the guide fences.
3.
place the sub fences so that the face of the sub fence
becomes flat against the bar. After that, tighten the
bolts.
► 1. Bolt 2. Sub fence 3. Guide fence 4. Rigid bar
43 ENGLISH
1
Adjusting the sub fences
Loosen the bolts securing the sub fences using
Place a straight rigid bar, such as a square steel
While the bar is flat against the guide fences,
3
4
1
2
4
2
Publicidad
Tabla de contenido
