Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Use the hex wrench to loosen the hex bolt holding
the center cover. Then, raise the blade guard and cen-
ter cover.
2
1
► 1. Hex wrench 2. Hex bolt 3. Center cover 4. Blade
guard
3.
Press the shaft lock to lock the spindle and use
the hex wrench to loosen the hex socket bolt clockwise.
Then remove the hex socket bolt, outer flange and
circular saw blade.
► 1. Hex socket bolt (left-handed) 2. Outer flange
3. Shaft lock
4.
spindle with its recessed side facing the circular saw
blade. If the flange is installed incorrectly the flange will
rub against the machine.
3
1
► 1. Hex socket bolt (left-handed) 2. Outer flange
4
Installing the blade
the spindle, always be sure that the correct ring
for the blade's arbor hole you intend to use is
installed between the inner and the outer flanges.
Use of the incorrect arbor hole ring may result in the
improper mounting of the blade causing blade move-
ment and severe vibration resulting in possible loss
of control during operation and in serious personal
injury.
saw blade so that the direction of the arrow on the
blade matches that on the blade case. Failure to do
so may result in personal injury and cause damage to
2
the tool and/or the workpiece.
1
To install the circular saw blade, perform the following
steps:
1.
inner flange. Make sure that the direction of the arrow
on the circular saw blade matches the direction of the
arrow on the blade case.
3
► 1. Arrow on blade case 2. Arrow on circular saw
21 ENGLISH
If the inner flange is removed, install it on the
2
3
7
3. Circular saw blade 4. Ring 5. Inner flange
6. Spindle 7. Recessed side
WARNING:
Before mounting the blade onto
CAUTION:
Make sure to install the circular
Mount the circular saw blade carefully onto the
blade
4
5
6
1
2
Publicidad
Tabla de contenido
