Care And Maintenance; Troubleshooting - AquaSource 67297-6101 Manual De Instrucciones

Ocultar thumbs Ver también para 67297-6101:
Tabla de contenido

Publicidad

OPERATING INSTRUCTIONS
1.
After the installation is complete:
a. Remove the aerator from the faucet (A) using a
coin (not included).
b. Turn on the water supply and allow both hot and cold
water to run for at least one minute each.
c. While the water is running, check for leaks.
d. Replace the aerator.

CARE AND MAINTENANCE

• Clean carefully by gently wiping with a grit-free damp cloth.
• Use only mild soap with water.
• Never use acids, harsh chemicals, or abrasive detergents to clean the surface.

TROUBLESHOOTING

PROBLEM
There is a leak from
under the handle or
there is a leak from
the spout when the
faucet is off.
There is a leak from
aerator when the
faucet is on.
The aerator has
irregular or reduced
water flow.
POSSIBLE CAUSE
1. The bonnet nut is not tight enough.
2. The cartridge is damaged.
The aerator does not fit correctly on
the faucet.
The aerator is dirty.
1
A
CORRECTIVE ACTION
1. Remove the handle and retighten
the bonnet nut.
2. If the problem occurs after
retightening the bonnet nut, call
customer service for a new cartridge
and replace it after you receive the
new cartridge.
1. Reinstall the aerator.
2. Call customer service for a new
aerator and replace it after you
receive the new aerator assembly.
Remove the aerator and clear debris.
7
Lowes.com

Publicidad

Tabla de contenido
loading

Tabla de contenido