AEG IMS 4440 Manual De Instrucciones página 42

ENGLISH
42
16 button (iPod/iPhone music selection)
17 button (tune down)
18 VOL- button
19 button (iPod/iPhone music selection)
20 SNOOZE/SLEEP button
21 button (On/Off)
First Use of the Device/Introduction
CAUTION:
• Do not place objects (such as vases) on top of the
device. Moisture seeping into the device can cause
serious damage.
• Do not place naked flames (such as burning candles)
on top of the device.
• Select a proper place for the device such as a dry, and
even non slip area where you can easily operate the
device.
• Make sure the device is vented sufficiently!
• If still in place, remove the protection foil from the
display.
Inserting the batteries (Backup)
(Batteries are not included with the device)
In case of a power cut or if the device is unplugged, with
batteries inserted, the settings will be kept.
1. Open the battery compartment (11) at the bottom.
2. Insert 2 R03 "AAA" batteries 1.5V. Mind the correct
polarity (indicated on the bottom of the battery case)!
3. Close the battery case.
4. If the device is not used for an extended period of
time, remove the batteries from the device to avoid
any leaking of battery acid.
CAUTION:
• Never use different battery types or new and used
batteries together.
• Batteries must not be disposed of in the garbage.
Please bring used batteries to competent collection
centers or back to the dealer.
WARNING:
Never expose batteries to high temperatures or direct
sunlight or throw batteries into fire for danger of
explosion!
Power supply
• Insert the grid plug into a properly installed three
prong socket with 230V, 50Hz. Connect the device
with the plug connector by inserting its plug into the
DC 12V jack of the device.
• Make sure the grid voltage corresponds to the figures
on the rating plate.
• If no backup battery is inserted, time and station set-
tings will be deleted during a power failure or when
disconnecting from mains power supply.
CAUTION:
• Only use the supplied power adaptor for this device.
Do not use for other devices.
• Only use power adaptor with 12V (
adaptors may cause damage to the device.
NOTE:
Disconnect from mains power supply during longer
periods of non-use.
Insert/Replace Battery in Remote Control
NOTE:
Where necessary, the lithium cell in the battery com-
partment of the remote has been fitted with a protec-
tive foil for transport. This extends the lifetime of the
battery. Before initial use please remove this foil to
prepare the remote for use.
The battery in the remote is a long-life lithium cell. Should
the range of the remote shorten during use, follow the
steps below:
• Open the battery compartment on the underside of
the remote.
• Replace the cell with a battery of the same type
(CR 2025). Make sure the polarity is correct.
• Close the battery compartment.
If the remote is not in use for a lengthy period of time,
please remove the battery to prevent the battery acid
from "leaking".
WARNING:
• Do not expose batteries to intense heat or direct
sunlight. Never throw batteries onto a fire. Danger
of explosion!
• Keep batteries out of the reach of children. They are
not toys.
• Do not force batteries open.
• Avoid contact with metallic objects. (Rings, nails,
screws etc.) Danger of short circuits!
• Short circuits may overheat or even ignite batteries.
This may lead to combustion.
• When transporting the batteries, cover the terminals
for your safety with an adhesive strip.
• If a battery leaks, do not rub the fluid into the eyes
or the skin. If acid comes into contact with the eyes,
rinse with purified water and seek medical advice if
symptoms persist.
), other