Preparation; Basic Settings - Steinbach S63 Manual De Instrucciones

When all indicators blink, the cleaning cycle is finished.
If all indicators are lit, the device has a fault. Contact customer service.
CYCLE function
11
Use this function to set the cleaning cycle.
Use the CYCLE button
11
ON/OFF function
12
Use this function to switch the device ON and OFF.
Use the ON/OFF button
12
- ON (Switches the device on and starts the selected cleaning cycle.)
- OFF (Stops the selected cleaning cycle and switches the device off at the same time.)

Preparation

Basic settings

Adjusting the nozzles
The following settings are recommendations. Adapt the basic settings to the actual properties of your
pool.
0°/30°: for most pools
0°/40°: to cover a large cleaning area
20°/20°: for round pools
Installing the brush
The brush can improve the cleaning of your pool, depending on the conditions on site, such as type
6
and quantity of dirt or surface structure of the bottom. Only operate the device with the brush installed if
this leads to a better cleaning result.
1. Press the brush strip
on the bottom of the bottom part
2. Make sure that the brush strip
completely engaged and fits tightly.
The brush is installed.
Removing the brush
1. Unlatch the hook of the brush strip
part at the same time.
4
2. Take out the brush strip
The brush is removed.
to switch between the cleaning cycles.
to switch between the following functions:
into the indentation
6
.
4
has
6
from the inside and press the brush strip out of the bottom
6
.
6
1
2
6
4
25