Steinbach S63 Manual De Instrucciones página 27

5. If necessary, adapt the running time of the cleaning cycle to the size of your pool, see section
"Functions of the control unit".
Inserting the filter unit
1. Insert the filter unit
3
.
4
2. Push the top part
2
until it has snapped into place on both sides.
The filter unit is inserted.
Placing the device in the pool
1. Completely unroll the floating cable
place it next to the pool without twisting.
2. Hold the device by the handle
slowly into the water (tipped slightly forward)
until all the air has escaped.
3. Let the device sink to the bottom while you
slowly feed more floating cable
the device in a controlled manner.
Make sure that the device lands on the
bottom of the pool on its underside and that
cleaning can start without obstruction
towards the center of the pool.
The device is in the pool.
Connecting the control unit
1. Only let as much of the floating cable
the pool.
into the bottom part
onto the bottom part
4
and
1
and lower it
8
to lower
1
into the water so that the device can reach all the spots in
1
3
3
4
4
2
4
5
27