Charging A Battery - Stanley SXAE00026 Manual De Instrucciones

2.7. Battery tests and error indications
The battery charger is designed to determine the battery's condition before and while charging, and
inform about any connection faults between the battery charger and the battery to charge. An error
code can be viewed on the digital display, which allows the fault to be quickly and simply checked
out.
Display indication
3. Instructions manual
Turn OFF ignition (heating, lighting...) before using the charger
when battery is installed in the vehicle.
Clean the battery terminals before using the charger.

3.1. Charging a battery

1. Before connecting the charger: make sure that the power supply lead is not plugged
into the mains !
2. Connection to the battery
CAUSE
The clamps/rings of the output
lead are not connected correctly
to the battery.
Polarity reversal
Battery voltage too high.
You are attempting to charge a
24V battery.
The battery may be defective.
Battery cannot maintain a good
level of charge.
Battery unrecoverable after a
complete desulfurization cycle.
The loading current would be too
high, in Supply mode.
Battery capacity excessive.
Battery voltage too low (under
0.8V). Battery cannot be charged.
Leads disconnected, leads short-
circuited.
Battery completely short-circuited. The battery may be defective.
SOLUTION
Position the clamps/rings correctly
and start charging the battery again.
Check the battery voltage.
Contact your battery service center.
The battery may be defective.
Contact your battery service center.
The battery may be defective.
Contact your battery service center.
Reduce the loading current below
5A.
Use a battery charger with greater
charging capacity.
The battery may be defective.
Contact your battery service center.
Position the clamps/rings correctly
and start charging the battery again.
Contact your battery service center.
7