Product Overview - Receiver - LEGRAND C2G C2G30030 Manual Del Usuario

HDMI HDBaseT + USB-B to A and RS232 over Cat Extender Single Gang Wall Plate
Transmitter to Box Receiver - 4K 60Hz
Product Overview
Front Panel
2
1
F P D
RONT ANEL ESCRIPTION
On: Power is applied to the device.
1 Power LED
Off: No power is applied to the device.
Blinking: The device is working properly.
2 Status LED
Off: The device is not working properly.
On: HDCP protected content is being transmitted.
3 HDCP LED Blinking: Non-HDCP protected content is being transmitted.
Off: No content is being transmitted.
On: HDBT link is normal.
4 Link LED
Off/Blinking: No HDBT link or link error.
Receiver
4
3
Rear Panel
6
5
R P D
EAR ANEL ESCRIPTION
Connect to a DC 12V power adapter. With one-way PoH function
5 DC 12V
supported, the transmitter can be powered by the receiver.
6 HDBT IN Connect to the transmitter via a Cat 5e/6/6a/7 cable.
7 RS232 For bi-directional RS232 pass-through.
8 HDMI OUT Connect to an HDMI display device.
Unbalanced stereo audio output.
9 Audio Out Pass-through: Reserved.
De-embed: For audio de-embedding from the HDMI output.
Connect to USB devices (e.g. keyboard, mouse, USB camera, USB
flash drive, etc.).
10 USB Device
Note: USB ports support the USB 2.0 standard with a maximum of
1.4A for the top two ports and 0.6A on the bottom two ports. Before
connecting a USB 3.0 device, confirm its compatibility with USB 2.0.
3
Receiver
8 10
7 9
(us)