Wiring - LEGRAND C2G C2G30030 Manual Del Usuario

HDMI HDBaseT + USB-B to A and RS232 over Cat Extender Single Gang Wall Plate
Transmitter to Box Receiver - 4K 60Hz

Wiring

Warnings:
Before wiring, disconnect the power from all devices.
•
During wiring, connect and disconnect the cables gently.
•
Steps for device wiring:
1. Connect an HDMI source to the HDMI IN port of the
transmitter.
2. Connect an HDMI display to HDMI OUT port of the receiver.
3. Connect HDBT OUT port of the transmitter to HDBT IN port of
the receiver via a single Cat 5e/6/6a/7 cable.
4. Connect additional functions options.
USB pass-through: Connect USB host PC to HOST port of
•
the transmitter, and connect USB devices such as keyboard
and mouse to USB DEVICE ports of the receiver. The
connected USB devices can be connected to the host PC.
RS232 pass-through: Set the DIP switch of the transmitter
•
to PASS-THROUGH position, connect a RS232 enabled
device such as a PC to RS232 port of the transmitter and
receiver respectively.
5. Connect the provided DC 12V power adapter to the receiver.
Note: With one-way PoH function supported, the transmitter can
be powered by the receiver, no additional power adapter is
needed to be connected to the transmitter.
6. Power on all attached devices.
5
(us)