Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
User Guide Fleck 3900-NXT
3.3.
Components description and location
3.4.
Bypassing
If the system is equipped with a bypass and if a problem occurs, turn the valves to bypass the system as shown in the picture
below.
Normal operation
Out
4 .
Programming
Note:
The controller must be plugged in to be programmed.
After 5 minutes with no button pressed, the unit returns to normal operation without saving.
4.1.
Basic programming
Note:
Menus are displayed in a defined and incremental order.
Choice of language
A
Press
and
B
Select the language to be displayed with
C
Press
to validate the selection and advance to the next parameter.
Feed water hardness
Note:
This parameter is not visible in Timeclock mode, and allows to adjust the water hardness.
D
Adjust the hardness with
E
Press
to validate the selection and advance to the next parameter.
Calendar override
Note:
Determine the maximum number of days of operation without regeneration.
F
Adjust the number of days with
G
Press
to validate the selection and advance to the next parameter.
6 / 36
Status LED
LCD display
UP/DOWN button
Shift button
Outlet
Regen button
Diagnostic button
Softening System
In
simultaneously for 5 seconds to enter the menus sequence.
and
and
.
and
.
Softening System
Out
.
Drain
Inlet
In Bypass
In
SELECT LANGUAGE:
ENGLISH
WATER HARDNESS
DEGREE
0030fTH
CALENDAR
OVERRIDE 03 DAYS
Ref. MKT-UG-015 / B - 04.05.2018
Brine
Publicidad
Tabla de contenido
