Toshiba RAV-SM564UTP-E Manual Del Proprietário página 37

„ Setting the louver lock
1
UNIT LOUVER
Push and hold the button (right side of
the button) for at least 4 seconds while
running is stopped.
blinks.
• When no unit number is displayed, all units are
selected.
2
Push the button (left side of the button)
to select a unit.
The unit number changes each time you push the
button.
Unit No. Unit No. Unit No.
1-1 2-1 3-1
Unit No.
4-1
The fan of the selected unit runs, and the louver
swings.
3
Push the "TEMP. " buttons to
display the number of the louver to fix its
direction.
The selected louver swings.
4
Push the buttons to select the
direction of the louver you do not want to
swing.
(1) (2) (3)
0001 0002 0003
(4) (5)
0004
0005
* If (4) or (5) is selected, condensation may occur
during cooling.
5
Push the button to confirm the setting.
When the setting is confirmed, the mark lights
up.
(To set the louver lock of another unit, repeat from
Step 2. To set another louver lock of the same unit,
repeat from Step 3.)
6
Push the button to finish the setting.
71-EN
0001 - 0005
(Louver position
Louver No.
code)
* F1 appears in the CODE No. section on the
remote controller. This indicates that the louver
01 shown in the following figure is selected.
Electrical control box
03
Refrigerant
pipe
04 02
Drain pipe
01
NOTE
Even in louver lock mode, the louver temporarily
moves in the following cases:
• When the air conditioner is stopped
„ „ Releasing the louver lock
Set "0000" in Step 4 of "Setting the louver lock".
The mark disappears.
* Steps 1 - 3 and 5, 6 of "Setting
the louver lock" also apply to SET DATA
releasing the lock.
◆ Adjusting the horizontal direction
1
Push and hold the and "TEMP.
buttons for at least 4 seconds while running
is stopped.
blinks.
"01" appears in CODE No.
2
Push the button (left side of the button)
to select a unit
The unit number changes each time you push the
button.
Unit No. Unit No. Unit No.
1-1 2-1 3-1
No Unit No.
display 4-1
The fan of the selected unit runs, and the louver
swings.
3
Push the "TEMP. " buttons to
change the CODE No. to "45".
4
Push the "TIME "buttons to select a
direction.
Direction SET
Direction setting
DATA
Smudging reduction position
"0000"
(reduces ceiling smudging)
Cold draft position
(Less directly expose your body to
"0002"
cool air)
(factory default)
5
Push the button to check the settings.
The indicator stops blinking and stays lit, and the
settings are confirmed.
6
Push button to finish the setting.
* If the cold draft position is selected, the ceiling
smudging reduction effect will be reduced.
– 36 –
0000
"
72-EN