Fax +32 2 359 95 50
Never move the appliance by pulling the cord. Make sure the cord
cannot get caught in any way. Do not wind the cord around the
appliance and do not bend it.
Stand the appliance on a table or flat surface.
Make sure the appliance has cooled down before cleaning and
storing it.
Make sure the cord never comes into contact with the hot parts of
the appliance.
The temperature of the accessible surfaces may be very high
when the appliance is in use. Make sure not to touch these
hot parts of the appliance.
Make sure the appliance never comes into contact with
inflammable materials, such as curtains, cloth, etc. when it is in
use, as a fire might occur.
Be careful not to scratch the special coating of the baking plates,
as you might get little pieces of this coating into the food. Use a
classical wooden spatula or a heat-resistant plastic one.
Always unplug the appliance when it is not in use, especially
since it is not equipped with an on/off switch.
Only use the appliance for food that is supposed to be cooked.
Your appliance must never be switched on through an external
timer or any kind of separate remote control system.
Please note: Should the symbol
surface, you need to be careful when handling the product. This
symbol means: CAUTION, this surface may get very hot during
use.
The symbol
temperature, however the other metallic or non-metallic surfaces
can also become very hot during use and it is therefore advisable
to always handle them with care and if possible with the help of
isothermal gloves or other thermal protection. In case of doubt
concerning the temperature of a certain surface it is always
preferable to protect oneself.
(*) Competent qualified electrician: after-sales department of the
producer or importer or any person who is qualified, approved and
competent to perform this kind of repairs in order to avoid all danger.
In case of need you should return the appliance to this electrician.
Copies of the I/B. Please reproduce them without any
changes
except
under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
is always put on the surface with the highest
7
Assembly page 7/36
special
instruction
be indicated on a certain
TKG SM 1006 - 140107
from
Team