SCOPREGA GE21-1A Instrucciones página 12

6. INTRODUCTION
The GE 21-1A is a next-generation high-efficiency portable electric inflator, which stands for reliability
and functionality. The GE 21-1A is equipped with a double-piston pumping unit that allows any object
to be inflated to a pressure between 10 and 1,500 mbar. The inflator starts when the ON button is
pressed and automatically stops when the set pressure in the pressure gauge is reached. The device
stops when the user presses the OFF button.
The GE 21-1A is fully portable as the battery is integrated in the device. When the battery is low (red
light on the pressure gauge), the inflator can be connected to a cigarette lighter socket or to an
external 12V battery via the power clamps. The battery can also be charged by a 12V cigarette lighter
plug or 110-240 AC/DC adapters.
The inlet port is protected by a multilayer filter, the outlet port is equipped with a check valve.
The unit is protected against overheating. In the event of high outside temperature or overuse, the
inflator will automatically stop and a red LED on the pressure gauge will indicate its status. The device
can be restarted when the red LED goes OFF.
7.RECOMMENDED USES
Inflatable items, such as: SUPs / Small rubber dinghies (3/4 m) / Kayak / Kites / Rafts / Air
mattresses / Swimming pool floats / etc.
8. TECHNICAL SPECIFICATIONS
SAFETY FUSE
MAX. PRESSURE
FLOW RATE
ITEM FUNCTIONS
(mbar)
(L / minute)
GE 21-1A
125
30 A 1,500 (22 PSI) INFLATION
PRESSURE SETTINGS: PRESSURE GAUGE WITH AUTOMATIC SWITCHING OFF
INFLATION FITTINGS: AVAILABLE FOR MOST COMMON VALVES
CARRY BAG DIMENSIONS: 220x320x220 mm
9. USE FOR INFLATING
ACCESSORIES AND POWER CABLES
1. The 12V cable and the fitting bag are located inside carry bag upper compartment.
2. The inflation hose is located inside the box, outside the carry bag.
3. The battery charger and the fuse are located inside carry bag lower compartment.
CONNECTING THE ACCESSORIES
1. The inflator is supplied with standard conical adapters that are located inside carry bag upper
compartment.
2. Make sure that the OFF button has been pressed.
3. Take the hose from the carry bag.
4. Connect the air hose to the port to inflate (OUT).
5. Assemble the most suitable adapter for the inflator
TURNING ON THE INFLATOR
1. To INFLATE, connect the hose to the outlet port (N5 fig. on p.3).
2. Set the desired pressure on the pressure switch (N1 fig. on p.3).
3. The device starts when the ON button is pressed.
The inflator will automatically stop when the set pressure is reached.
12