SCOPREGA GE21-1A Instrucciones página 13

WARNING
Be careful when connecting the cable to the battery, in order not to short the battery with
conducting materials such as rings, bracelets and keys. The battery or adapter may overheat
and cause injury.
WARNING
Check the voltage. Do not connect the 12V inflator to a 24V battery.
WARNING
Do not leave the inflator running unattended. Overinflating an object could result in serious
injury.
WARNING
RISK OF EXPLOSION! Excessive pressure may result in explosions or personal injury. Before
inflating, always check the maximum inflator pressure indicated by the manufacturer.
THE INFLATOR CAN BE DAMAGED BY SAND, DUST OR WATER GETTING INSIDE THE INLET PORT. THIS
WILL CAUSE OVERHEATING AND WILL DAMAGE THE TURBINE. SHOULD THIS BE THE CASE, IMMEDIATELY
11. TROUBLESHOOTING
PROBLEM
The ON button has not been pressed.
The inflator does
not start
The inflator does
not inflate
11.1 ACCESSORY WARNING
The recommended accessories when using the inflator are the original SCOPREGA ones.
The use of any accessory not recommended for this inflator can be dangerous.
SWITCH THE INFLATOR OFF.
POSSIBLE CAUSE
Battery LOW
The safety fuse is blown or
disconnected.
The device is damaged
Hose wrong connection.
Wrong pressure setting
POSSIBLE SOLUTION
Recharge the battery using the 110-240V
battery charger or connect the device to a
cigarette lighter socket
Press the ON button.
Insert or replace the fuse with one of
the same type (30 A).
Contact a SCOPREGA service
centre.
Correctly connect the hose to the inflation
port (N5 fig. on p.3)
Correct pressure setting.
13