Water Ace R7L Manual De Instalación página 6

STEP
11
Remove the 1-1/2"
pipe plug from the
Discharge Tee RDT-15.
Fill the pump until
water is standing in
the discharge tee.
This may take several
minutes.
STEP
12
Thread the 1-1/2"
pipe plug back
into the top of the
Discharge Tee RDT-15.
STEP
13
Start the motor. When the pump primes, you should
have water coming out of the sprinklers (existing
systems) or riser pipes/tees (new systems). If the pump
is 4 feet or more away from the well, it may take a few
minutes to prime. If you aren't getting water after 5
minutes, stop the motor, unscrew the plug from the
discharge tee, add more water, and try again.
23833A308
NEW INSTALLATIONS ONLY
STEP
14
1-1/2" PIPE PLUG
1-1/2" PIPE PLUG
WARNING: Risk of explosion if the pump runs for an
extended period with no water fl ow through it. Make
sure the discharge valve is open when the pump is
running. If the pump runs with no fl ow, it can overheat
and may explode, causing severe burns to anyone near
5
Allow the pump to run long enough to clear the
well, pump, and piping of sediment and debris from
installation, and to make sure that the well will not run
dry. Thread the sprinkler heads into the riser pipes or
tees after the pump and piping have been thoroughly
fl ushed.
and serious damage to the installation.