Panasonic S-15MK2E5A Manual Del Usuario página 9

(2) For the Right and Right Bottom Piping
Step 1 Pull out the Indoor piping
↓
Step 2 Install the Indoor Unit
↓
Step 3 Insert the power supply cord and connection
cable
↓
• Insert the cables from bottom of the unit
through the control board hole until terminal
board area.
Step 4 Secure the Indoor Unit
Right and Right Bottom piping
Tape it with piping
in a position as
mentioned in
Fig. below.
Piping
Cover for
Drain hose
the right
piping
(3) For the Embedded Piping
Step 1 Replace the drain hose
↓
Step 2 Bend the embedded piping
↓ • Use a spring bender or equivalent to bend
the piping so that the piping is not crushed.
Step 3 Pull the connection cable into Indoor Unit
↓
• The power supply cord and indoor unit
and outdoor unit connection cable can be
connected without removing the front grille.
Step 4 Cut and flare the embedded piping
↓
• When determining the dimensions of the
piping, slide the unit all the way to the left on
the installation plate.
Step 5 Install the Indoor Unit
↓
Step 6 Connect the piping
↓
Step 7 Insulate and finish the piping
↓
Step 8 Secure the Indoor Unit
Cover for
Cover for the
the left
bottom piping
piping
Fig. 3-13
9
Install the indoor unit
Hook the indoor unit onto the upper portion of installation plate.
(Engage the indoor unit with the upper edge of the installation
plate). Ensure the hooks are properly seated on the installation
plate by moving it in left and right.
Indoor unit
Secure the Indoor Unit
Press the lower left and right side of the unit against the
installation plate until hooks engages with their slot (sound
click).
Unit's hook
Insert the connection cable
Guide
surface
PUSH marking
To take out the unit, push the PUSH marking at the
bottom unit, and pull it slightly towards you to disengage
the hooks from the unit.
(This can be used for left rear piping and bottom piping also.)
Hooks at installation plate
Sleeve for piping hole
Piping
Drain hose
Fig. 3-14
Installation plate
Fig. 3-15
Connection cable
Gas side piping
Liquid side piping
Drain hose
Connection
cable
Fig. 3-16
Fig. 3-17