Movement R4 Manual Del Propietário página 45

2 - Instructions for LCD display
2.1: "DISTANCE" window displays the distance value in numbers.
2.2: "CALORIES" window: Displays the number of calories
2.3: "TIME" window: Displays the time in numbers.
2.4: "SPEED" window: Displays the speed in numbers.
2.5: "PULSE" window: Displays the pulse in numbers.
3 - Instructions for the buttons
3.1 "PROGAMA": Program selection key: with the belt stopped, select the manual program
cycle for "P1-P36 → U1 ~ U3 → FAT" according to your preference. The standard speed of the
manual program is 1.0 km / h. The highest speed is 13 km / h.
3.2: "MODE": mode selection key: with the mat stopped, set the Mode according to your
preference.
You can select "Time countdown → calories countdown → distance countdown → Normal
mode".
The return to the default occurs every 30 minutes in programs P1-P36. It is not possible to select
the "FAT" program when in "FAT" mode.
3.3: "START / PAUSE" key: With the belt stopped, press the START key to turn the belt on. When
pressing the "START" key while the belt is moving, it will stop.
3.4: "STOP" key: with the conveyor moving, to stop the conveyor slowly, press the "STOP" key
once. When the LCD display shows the ERR message, press the "STOP" key to clear the
message. With the conveyor moving, press the "STOP" key twice, and the conveyor stops
immediately.
3.5: "SPEED +" key: increases the speed with the moving belt.
Increases the parameter in the body fat test.
3.6: "SPEED -" button: reduces the speed with the moving belt. Reduces the parameter in the
body fat test.
3.7: "SPEED SHORTCUT" key: with the belt moving, increase the speed by pressing the
"SPEED SHORTCUT" key 2, 5, 7, 9, 11, 13.
4 - Key security function
In any state, when the safety key is pulled out, the display shows "E7" and the audible alarm
sounds. When the security key is reinserted, the panel lights up for 2 seconds and goes into
manual initialization mode (equivalent to a complete reset).
5 - Instructions for connecting
5.1: Connect the power cord to a 20 A outlet. Place the switch in the "ON / ON" position. The
screen will light up and beep.
5.2 Place the safety key in the correct position and connect the belt. The LCD display light comes
on and beeps. The belt enters Normal Mode P0.
5.3 Press the "PROGRAM" key to select the program P0-P36, U01, U02, U03, FAT.
a) "P0" user program. Press the "MODE" key to select the mode
training. The user can select the speed and incline. The velocity
default is 1.0 km / h. The default slope is 0%.
Training mode 1: Count. Time, distance, calories. The selection function is complete.
Training mode 2: Time countdown. In selection, with the window flashing time, press "+" or
« -" to change the value. The time range varies between
5-99 minutes. The default is 30 minutes.
Training mode 3: Distance countdown. In the selection, with the flashing distance window,
press "+" or "-" to modify the value. The range of distance ranges from 1.0 to 99.0 km. The default
is 1.0 km.
16