Publicidad
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
PERIODICAL MAINTENANCE
Check the solidity and the stability of the gate, especially the points of support and/or rotation of the gate
(pivots).
Check the release function
Check and grease the fixing pivots and the endless screw
Check the integrity of the connection cables
Verify the functionally and the conditions of the limit switch stops in opening and closing (where foreseen)
Verify the good condition of all apparatus which are subject to stress (back attachment, oscillating fork and
front attachment)
Check the functionality of all the accessories, in particular way of all safety disposals
After having executed the periodical maintenance it is necessary to repeat the test of the automation
and its putting in service
All the above described operations MUST be made exclusively by an authorized installer.
INITIAL TEST AND STARTING OF THE AUTOMATION
After having completed the necessary operations for a correct installation of the SURF product, as described in this manual, and after having
valuated all resting risks which could arise in any installation, it is necessary to test the automation to guaranty the maximum security
and, in particular way, to guaranty that the laws and norms of this sector are fully respected. Especially the test must be executed
following the norm EN 12445 which establishes the methods of tests for checking the gate automations respecting the limits established by the
rule EN 12453.
RISK EXAMINATION
The points pointed by arrows in
conveying, cutting, grappling, trapping so as to guarantee a safe installation for people, things and animals (
where installation has been made
Fig. 22
SAFETY PRECAUTIONS:
All electrical work should conform to current regulations. A 16 A 0,030 A differential switch must be incorporated into the source of the operators
main electrical supply and the entire system properly earth bonded. Always run mains carrying cables in separate ducts to low voltage control
cables to prevent mains interference.
SPARE PARTS:
To obtain spare parts contact:
SEA
S.p.A.
-Zona Ind.le, 64020 S. ATTO Teramo Italia
SAFETY AND ENVIRONMENTAL COMPATIBILITY:
Don't waste product packing materials and/or circuits.
When being transported this product must be properly packaged and handled with care.
LIMIT OF GUARANTEE
For the guarantee see the sales conditions on the official SEA price list.
MAINTENANCE AND OUT OF SERVICE:
The decommission and maintenance of this unit must only be carried out by specialised and authorised personnel.
NOTE: THE MANUFACTURER CAN NOT BE DEEMED RESPONSIBLE FOR ANY DAMAGE OR INJURY CAUSED BY IMPROPER USE
OF THIS PRODUCT.
SEA reserves the right to do changes or variations that may be necessary to its products with no obligation to notice.
22
67411010
®
Fig
. 22 are potentially dangerous. The installer must take a thorough risk examination to prevent crushing,
).
NOTICE
SEA S.p.A. can not be deemed responsible for any damage or accident caused
by product breaking, being damages or accidents due to a failure to comply with
the instructions herein. The guarantee will be void and the manufacturer
responsibility
(according to Machine Law)
spare parts are not being used.
The electrical installation shall be carried out by a professional technician who
will release documentation as requested by the laws in force.
from the GENERAL DIRECTIONS that the installer must read carefully before
installing.
Packaging materials such as plastic bags, foam polystyrene, nails etc must be
kept out of children's reach as dangers may arise.
Rev. 09 - 07/2013
SURF
English
English
Annual
Annual
Annual
Annual
Annual
Annual
Annual
Annual
Re. Laws in force in the country
will be nullified if SEA S.p.A. original
This is a quotation
Publicidad
