Tabla de contenido
Publicidad
Maximum Distance
Each twisted pair port has a maximum operating distance of 100 meters
(328 feet).
Auto MDI/MDI-X
All of the twisted pair ports on the switch are auto-MDI and IEEE 802.3ab-
compatible. The ports use the auto-MDI feature to automatically configure
themselves as MDI or MDI-X when connected to an end-node.
Consequently, you can use a straight-through twisted pair cable to
connect any network device to a port.
LEDs
The system and port LEDs on the front panel of the AT-FS708 switch
display status information. Each port has three LEDs.
Table 1 describes the system and port LEDs on the AT-FS708 Fast
Ethernet switch.
LED
POWER
LINK/ACT
100M
FDX
AC Power
The AT-FS708 Fast Ethernet switch has a single AC power supply socket
on the back panel, which has an auto-switch AC input. Refer to Appendix
Connector
A, "Technical Specifications" on page 34, for the input voltage range.
To power ON or OFF the switch, you connect or disconnect the power
cord.
Table 1. System and Port LEDs
State
Green
The switch is powered ON and operating
normally.
OFF
The switch is not receiving power.
Green
A valid link is established on the port.
Blinking Green
Frames are being transmitted/received
on the port.
OFF
No link is established on the port.
Green
The port is operating at a speed of 100
Mbps.
OFF
The port is operating at a speed of 10
Mbps.
Green
The port is operating in full-duplex mode.
OFF
The port is operating in half-duplex
mode.
AT-FS708 Fast Ethernet Switch Installation Guide
Description
15
Publicidad
Tabla de contenido
