Assembly And Adjustments - DeWalt DWE4010 Traducido De Las Instrucciones Originales

EN GLI SH
Your D WALT tool is double insulated in
E
accordance with EN 60745; therefore no
earth wire is required.
WARNING: 115 V units have to
be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
conductor size is 1.5 mm 2 ; the maximum length
is 30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Attaching Side Handle (fi g. 2)
WARNING: Before using the tool,
check that the handle is tightened
securely.
WARNING: The side handle should
always be used to maintain control of
the tool at all times.
28
Screw the side handle (d) tightly into one of the
holes (f) on either side of the gear case.
Mounting and Removing the Guard
(fi g. 3)
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Before
reconnecting the tool, depress and
release the trigger switch to ensure that
the tool is off.
CAUTION: Guards must be used with
this grinder.
TO MOUNT THE GUARD
1. Place the angle grinder on a table, spindle up.
2. Press the guard (c) down (fig. 3A).
3. Position the guard between your body and work
piece.
4. Tight the screw (l) holding the cinch collar
firmly around the neck of spindle (fig. 3B)
TO REMOVE THE GUARD
1. Loosen the screw (l) holding the cinch collar
around the neck of the spindle.
2. Lift up on the guard.
Fitting and Removing a Grinding Disc
(fi g. 1, 4, 5)
WARNING: Do not use a damaged
disc.
1. Place the tool on a table, guard up.
2. Fit the backing flange (g) correctly onto the
spindle (h) (fig. 4).
3. Place the disc (i) on the flange (g). When fitting
a disc with a raised centre, make sure that the
raised centre (j) is facing the flange (g).
4. Screw the outer flange (k) onto the spindle (h)
(fig. 5). The ring on the flange (k) must face
towards the disc when fitting a grinding disc.
5. Press the spindle lock button (b) and rotate the
spindle (h) until it locks in position.
6. Tighten the flange (k) with the hex key provided
or a two pin spanner.
7. Release the spindle lock.
8. To remove the disc, loosen the flange (k) with
the hex key provided or a two pin spanner.