Homelite UT43123 Manual Del Operador página 16

ADDING BAR AND CHAIN LUBRICANT
See Figure 7.
Use HOMELITE Bar and Chain Lubricant. It is
designed for chains and chain oilers, and is for-
mulated to perform over a wide temperature range
with no dilution required.
NOTE: Chain saw comes from the factory with
no bar and chain oil added. Level should also be
checked after every 20 minutes of use and refilled
as needed.
 Disconnect chain saw from power supply.
 Remove oil cap.
 Carefully pour the bar and chain oil into the tank.
 Wipe off excess oil.
 Check and fill the oil tank when quick view oil
indicator is below the second to last indicator
line.
 Repeat as needed.
NOTE: Do not use dirty, used or otherwise
contaminated oils. Damage may occur to the
bar or chain.
NOTE: It is normal for oil to seep from the saw
when not in use. To prevent seepage, empty the
oil tank after each use then run for one minute.
When storing the unit for a long period of time
(three months or longer) be sure the chain is lightly
lubricated; this will prevent rust on the chain and
bar sprocket.
CONNECTING TO POWER SUPPLY
See Figure 8.
This chain saw is designed with a cord retainer
that prevents the extension cord from being pulled
loose while using.
 Form a loop with the end of the extension cord.
 Insert loop portion of extension cord through
the opening in the side of the rear handle and
place over cord retainer.
OPERATION
QUICK VIEW
OIL INDICATOR
CORD
RETAINER
NOTICE:
Always secure extension cord to unit by using
cord retainer. Failure to use cord retainer may
result in damage to the unit and/or extension
cord.
 Slowly pull loop against cord retainer until the
slack is removed.
 Plug chain saw into extension cord.
NOTE: Failure to remove all excess cord slack
from extension cord retainer could result in plug
loosening from receptacle.
Page 16 — English
OIL RESERVOIR
EXTENSION
CORD
CAP
Fig. 7
Fig. 8